41
10. Programming the Speed Controller
a) Programming of Neutral and Full Throttle Positions
If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for
the driving function at the transmitter.
If the trim path is not sufficient (or if the trim is already almost at the end of the trim path) you can reprogram the neutral
position and the full throttle positions for forward/reverse driving.
Proceed as follows:
• Switch on the transmitter, but leave the throttle/brake in
the neutral position. Put the trimming for driving into the
centre position.
• Keep the setup button (2) pressed and turn the speed
controller on („ON“).
• The LED (3) then flashes red; the motor emits beeps.
Release the setup button again.
If you do not release the setup button, the programming
mode is activated after a few seconds. In this case,
switch off the speed controller and proceed again as
described above.
• Release the throttle/brake at your transmitter so that it sits in the neutral position.
• Push the setup button (2) briefly. The LED (3) at the speed controller flashes green once and a beep is emitted. The
neutral position is now saved.
The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depen-
ding on the motor. In this case, observe the LED on the speed controller.
• Move the throttle/brake lever to full throttle for forwards driving, pull it towards the handle and hold it there.
Attention!
If you do not move the transmitter throttle/brake lever during the programming process or do not move it
far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become
uncontrollable. In that case, repeat programming.
• Push the setup button (2) briefly. The LED (3) at the speed controller flashes green twice and two beeps are emitted.
The full throttle position for forward driving is stored.
• Move the throttle/brake lever to full throttle for reverse driving, push it away from the handle to the stop.
• Push the setup button (2) briefly. The LED (3) at the speed controller flashes green thrice and three beeps are
emitted. The full throttle position for reverse driving is stored.
• Release the throttle/brake so that it sits in the neutral position.
• Now wait for at least 3 seconds. The setting mode is left automatically and the speed controller is ready for operation
with the new settings made.
1
2
Æ
OFF ON
3
