Reely Sky QuadCopter 650 ARF, Руководство по эксплуатации

Страница: 12 / 52

12
 
8. Final Assembly of the QuadroCopter
a) Assembly of the Landing Legs
Attach one self-adhesive rubber buffer (2) each to
the four ends of the chassis reinforcement plate
(1) as displayed in figure 2a, item “A”. These rub-
ber buffers are used as stop buffers for the radial
arm (3).
Install the end pieces (4) to the four radial arms (3)
as displayed in figure 2a, item “B” and let the end
pieces catch in the locks.
Completely extend the four radial arms (3) and let
them catch in the locks (5), see figure 2a, item “C”.
Wind the hook and loop tapes (6) firmly around the
radial arm, see figure 2a, item “D”. The red hook
and loop tape must be installed on the radial arm
with a “direction arrow” and thus additionally indi-
cates the “front” of the Quadrocopter.
By installing the rubber buffers (figure 2a, item “A”) and the hook and loop tapes (figure 2a, item “D”), the
connection between radial arms and body is additionally stabilised. At the same time, this type of attach-
ment is sufficiently elastic for dampening harder landings. The measures shown also improve flight char-
acteristics.
Place the Quadrocopter upside-down on a suitable
basis. Install the four landing legs (1) on the bot-
tom of the chassis (2) as indicated in figure 2b. For
this purpose, use the eight screws from the deliv-
ery.
The bores in the plastic hood of the chassis must
be carefully drilled with a small drill before installa-
tion.
During installation, observe hat the landing legs
have an “upside” on the outsides and a “downside”
on the opposite side, where the hole for the attach-
ment screw is supposed to go.
Figure 2a
Figure 2b