Reely ROAD 23 58 10, Руководство по эксплуатации

Страница: 43 / 125

4
4WD MonsterTruck Destroyer XXL 1:8 No. 3 58 10
b) Tools and auxiliaries, check list for putting into operation
The Monster Truck Chassis Destroyer XXL“ is pre-assembled ready to run (RTR).
Before the first start, some basic adjustments must be carried out or checked and the necessary accessories and auxiliaries must be prepared.
Go through the various points of the check list one after the other, and your model is then ready to run.
Tools
Socket wrench 17 mm for the wheel nuts
Flat spanner 5 mm and 5,5 mm
to set alignment and inclination
Allen wrench 1.5 mm for the
headless screws at the adjusting rings of the
throttle / brake and steering linkage
Crosstip screwdriver
Screwdriver for the throttle stop screw and the main
nozzle needle
Auxiliaries
Cable fastener
Air filter oil
Low viscosity machine oil for lubrication and
to protect the combustion chamber against corrosive
residues in the engine, after operation („After Run”)
NOTE!
The instructions specific to position front / back / right / left always refer to the longitudinal
axis of the vehicle in drive direction “forward”!
c) Check alignment and tooth backlash of drive
The engine transmits its power via the pinion on the clutch bell to the two main pinions of the two-speed drive, which are connected with a one-way bearing.
Both rotary axes, i.e. the crank shaft, engine-sided, and the axis of the drive section to the front and rear axis, must be aligned so that they are exactly in
parallel. This prevents tensions in the drive section, premature wear of the pinions and bearing journals as well as loss of power.
The parallel alignment of crankshaft and drive section must be checked every time before using the vehicle and, if necessary, must be
readjusted!
When the alignment is in parallel, the pinion on the clutch bell and the main pinion will run smoothly.
If there is too much play, this will destroy the toothed wheels in the long run; too little play destroys the bearing in clutch and engine.
The tooth backlash should be checked for both pinions on the clutch bell and on the transmission.
Checking the tooth backlash
Insert a thin strip of paper both between the pinions on the clutch bell and be-
tween the main pinions of the two-speed transmission in the drive section.
Turn gears by hand;
the paper strips must not rip apart when the wheel turns!
Readjusting
Unscrew four screws of the engine mount fastener on the lower side of the moun-
ting plate (chassis)
Align engine laterally and fasten screws again tightly
Unscrew four screws, at the top, on the engine support and adjust the engine
lengthwise
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Check list for putting into operation
What must be done:
Check alignment and tooth backlash of drive
Function control of servos
Check the range of the remote control transmitter
Check basic carburettor setting
Fill in fuel
Let engine run
•
•
•
•
•
•