17
6. Press the
LOG
button again to save a reading to memory. Both the
memory position number and "DATARECORD" will flash each time a
data point is stored.
Note
: If a card is not inserted or the card is defective, the meter will flash
"EMPTY". In this case, power the meter OFF and try again with another
SD memory card or verify that the card is correctly inserted.
7. To exit manual data logging mode, press and hold the
REC
button
2 seconds to resume normal operation.
Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate can be set
between 1 second to 8 hours, 59 minutes and 59 seconds prior to
recording. In order to setup the meter for automatic data logging, follow
steps 1 through 5 below.
1. Press the
REC
button and "RECORD" will appear on the LCD.
2. Press the
LOG
button to enter automatic data logging function as
indicated by "DATARECORD".
Note
: If a card is not inserted or the card is defective, the meter will flash
"EMPTY" above "DATARECORD". In this case, power the meter OFF
and try again with another SD memory card or verify that the card is
correctly inserted.
3. The "DATARECORD" icon will appear on the LCD and will flash every
time a reading is stored.
4. To pause the data logging session press the
LOG
button and
"DATARECORD" will stop flashing. To resume press the
LOG
button again.
5. To end the current data logging session press and hold the
REC
button for 2 seconds.
Transferring Data from the SD Memory Card to a Computer
1. While the meter is powered Off remove the SD memory card from the
SD card slot.
2. Insert the SD memory card into the computer.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
