8
6. Turn the front Adjustment Knob (44) counterclock-
wise one half of a turn. Pull the Adjustment Knob
and insert the Handlebar Post (6) into the Frame
(1). Slide the Handlebar Post to the desired height,
release the Adjustment Knob, and move the
Handlebar Post up or down slightly until the
Adjustment Knob snaps into one of the adjustment
holes in the Handlebar Post. Then, retighten the
Adjustment Knob until it is snug; do not over-
tighten the Adjustment Knob.
6
44
1
6
7. Set the Lock Bushing (22) in the indicated hole in
the Handlebar Post (6). Next, loosen the Adjust-
ment Handle (21) in the Handlebar Post. Note: The
Adjustment Handle functions like an end wrench.
To loosen the Adjustment Handle, turn it as far as
possible, pull it downward, turn it in the opposite di-
rection, push it upward, and then turn it again.
Remove the front M6 x 8mm Set Screw (23) from
the Handlebar (5). Slide the Handlebar onto the
Handlebar Post (6) until it stops. Next, tighten the
front Set Screw into the Handlebar. Then, slide the
Handlebar backward until it stops and tighten the
rear M6 x 8mm Set Screw (23).
Slide the Handlebar (5) to the desired position, and
retighten the Adjustment Handle (21).
7
22
21
5
23
6
Hole
23
8. Identify the Right Pedal (34). Using a 15mm pedal
wrench, firmly tighten the Right Pedal clockwise
into the Right Crank Arm (36). Tighten the Left
Pedal (not shown) counterclockwise into the Left
Crank Arm (not shown). To avoid damaging the
indoor studio cycle, use only a 15mm pedal
wrench to attach the Pedals.
34
36
8
