
X-IP-SERIES USER MANUAL
9
The Redvision Wireless Card is compatible with the Redvision Wireless PIR, Luminite Genesis Range and the Redwall
Wireless Transmitter Module Part Code WF434T, (wireless enabled Redwall PIRs).
For the main specification and connection information for the WIRELESS ALARM PSU (RVIP-PSU-ALM-W), refer to
diagram. This section deals with the additional functions of the Wireless module.
•
1 to 3 dip switches are not used & should be left ‘ON’
•
Switches 4 to 8 (Dome Head Site Code) provide up to 32 (1 to 16 shown in the table above) channels of wireless
transmission to enable alarm activation.
•
The transmission needs to be matched between the Dome Head Site Code on the wireless alarm module & the Site Code
within the PIR detector (see separate PIR installation guide supplied with the PIR).
•
One or more domes wil respond to any wireless PIR within range providing the Dome Head Site Code & corresponding
PIR Site Code match.
3.3.1
RVIP-PSU-ALM-W INTERNAL CONNECTIONS (ADDITIONAL)
3.3.1.1 ANTENNA
CONNECTOR
BNC Connector, 50Ohm type
3.3.2
CONFIGURING WIRELESS ALARM MODULE
3.3.2.1
DIP SWITCH SETTINGS
3.3.2.2
AERIAL
3.3.2.2.1 POSITIONING OF RVIP-PSU-ALM16-W
To maximise the transmission range install the PSU externally with the aerial pointing through the gland towards the
ground. An optional booster aerial (RV-AE434) can be used to significantly improve signal and range. It is
recommended to use the booster aerial if the PIRs are installed on metal clad buildings.
3.3.2.2.2 RETRO FITTING WIRELESS ALARM RECEIVER
If retrofitting a wireless alarm receiver card onto an existing 16 way alarm module (RVIP-PSU-ALM16-W) observe the
following steps:
•
ISOLATE POWER FROM PSU - you cannot hot swap wireless alarm module.
•
Align Wireless Alarm Module with P3 Connector and secure with M3 fixings.
•
Thread aerial antenna through gland and connect to BNC on Wireless Receiver.
•
See Table 19, for DIP switch settings.
SW1
4
5
6
7
8
1
s
s
s
s
s
2
s
s
s
s
t
3
s
s
s
t
s
4
s
s
s
t
t
5
s
s
t
s
s
6
s
s
t
s
t
7
s
s
t
t
s
8
s
s
t
t
t
9
s
t
s
s
s
10
s
t
s
s
t
11
s
t
s
t
s
12
s
t
s
t
t
13
s
t
t
s
s
14
s
t
t
s
t
15
s
t
t
t
s
16
s
t
t
t
t
UP =
s
DOWN =
t
Содержание RVIP Series
Страница 28: ...X IP SERIES X IP SERIES USER MANUAL...