RedSeven Amplification MSLM, Быстрый старт

Страница: 12 / 15

12
DIRECT OUTPUT or D-OUT (selectable)
A dedicated dry output is available for an easy Wet/Dry/Wet application of the mixer in such as
situation, or if you’d like to have an unprocessed dry path to be recorded in your DAW or sent wherever
you need.
We also gave you the ability to select where this dry output is taken: PRE (D/OUT button off) is right at
the input of the mixer. You will have a copy of the signal coming from the inputs. POST (D/OUT button
on) this will take your signal after L3. Very useful if you’d like to have the serial processing in your center
cabinet. No gain or attenuation applied, the output from D/OUT is 1:1 in volume, compared to main
input signal.
SWITCH 1/2
A couple function switches are available, in order to turn on/off the features of some external devices
(amps, preamps, fx, etc.) These switches are latching, with HOT to ground with activated. They can be
both activated by front panel or via MIDI CC.
SW1/2 is the jack on the back, to use them in a proper way, you’ll need a Y cable, mono from two ends,
stereo from the other. TIP is SW1, RING is SW2, SLEEVE is ground.
DEDICATED DRY PATH
We’ve taken care of the dry signal, placing a dedicated audio bus only for the dry signal coming after
L3, right into the output stage. Your signal will never sound better than this, especially when mixing
other 5 units together. This dedicated dry path is also useful for a quick “kill dry” selection, if you don’t
want any dry signal in your L/R speakers.
BALANCED OUTPUTS
Two balanced outputs are available on the front panel. They are specular copies of the back outputs
and they can be used at same time. They are very convenient if you want to quick wire your system to
your DAW/mixer devices while leaving back outputs connected to you power amp for example.
MIDI (MIDI CHANNEL AND MIDI Control Changes)
The mixer has couple MIDI INPUT and a MIDI TRHU port.
One midi INPUT connector is placed on the back of the mixer, the other on the front panel out of
convenience of connection. They are internally wired in parallel, so they must be used only one at
time.
MSLM can operate with all 16 midi channels available, one at time (not OMNI mode). It will be shipped
with MIDI CH1 already stored, but you can change it with following procedure.
Once MSLM is turned on and no midi signal is coming thru it, you need to:
- Press together SW1 and AUX2 for couple seconds. All the illuminated pushbutton will start to
blink from left to right, as confirm you entered the setup mode;
- FX1 button will now blink, as confirm MSLM is waiting to receive the instructions;
- Now, you need to look at top row of illuminated red buttons named L1 – L2 – L3 – D/OUT
POST. The on/off status combination of these buttons, will determinate which midi
channel are you going to save. To change the status of a button, you just need to press
it, until it turns red, or the light will turn off.