RedSeven Amplification MSLM, Быстрый старт

Страница: 5 / 15

5
FRONT PANEL
(left to right)
1. FX1 to FX3 red illuminated buttons: these buttons turn on/off the three parallel FXs. When red
light is on, the effect is on.
2. DRY red illuminated button: this button turn on/off DRY path. When the red light is on, DRY
path is on.
3. AUX 1 & 2 potentiometers: those pots let you decide how much of the respective signals to
send to AUX 1, 2, or both auxiliaries loops. At maximum position, the send level is 1:1.
4. L1-L2-L3 red illuminated buttons: these buttons turn on/off the three serial loops. When red
light is on, the loop is active.
5. D/OUT post: red illuminated button: this button toggle the position of the dry output. When
the red light is on, DRY output is take after loop 3 (L3), when off, is taken at the very input of
the mixer (before L1).
6. SW1 – SW2: red illuminated buttons: this buttons turn on/off Switch 1 and 2. When the red
light is on, Switch 1, 2 or both are active.
7. AUX1 – AUX2: red illuminated buttons: this buttons turn on/off AUX1 and 2 processors. When
red light is on, AUX1, 2 or both are on.
8. MAIN OUTPUT (balanced): main output of the entire mixer. Fully electronic balanced, with XLR
connectors. They are a copy of back outputs and they can be used at same time (back and
front pair).
9. MIDI INPUT: midi input connectors, wired in parallel to back midi input connector. They should
be used one at time, to avoid any issue.
10. POWER BUTTON: it turn on/off the device. Do not turn it down when audio is running or when
your amplifier is on: this can cause loud noise.