11
PARTS SUPPLIED
ITEM DESCRIPTION
QTY
1
wall bracket
2
2
top bracket cover
1
3
sliding rail
1
4
soap-dish
1
5
hose-retainer
1
6
shower holder
1
7
bottom bracket cover
1
TOOLS REQUIRED
power drill
drill bit
cross head screw driver
pencil
BEFORE YOU START
a)
Identify all components and check pack contents.
b)
The screws and wall plugs supplied are only suitable for use in solid walls.
c)
Ensure there are no hidden service pipe or cables where you intend to drill.
d)
If drilling into ceramic tiles, please use a ceramic drill bit.
e)
Please be careful of your safety when drilling.
INSTALLATION
1)
Mark the positions of the two drill holes.
Drill the wall at marked positions by using the power drill and then insert the wall plugs.
2)
Make sure the screw hole of top wall bracket and the wall plugs are centre.
Then put the screw through the top wall bracket and tighten.
Make sure the round opening points downward.
3)
Put the shower holder, hose retainer and soap-dish into the sliding rail and ensure the larger opening of the
shower holder point upward.
Be sure that the notched end of the slider rail points downward.
4)
Assemble the non-notched end, sliding rail to the top wall bracket, and the notched end to the bottom wall
bracket.
Put the wall screw through the bottom wall bracket and fix it to the wall plug.
5)
Assemble the bracket and fix it to the wall plug.
6)
Insert the rubber washers into both ends of the stainless steel hose.
Then connect one end to shower handset and the other end to the shower outlet.
Please Note: Bracket with anchor is bottom wall bracket, bracket without anchor is top wall bracket.
AFTER CARE
a)
To maintain the appearance of this fitting, ensure it is cleaned only using a clean soft damp cloth.
b)
A solution of warm water and mild liquid detergent may be used where necessary and then rinsed
thoroughly.
Abrasive cleaners or acidic cleaners MUST NOT BE USED under any circumstances.
Avoid contact with solvents.
12