Redpath Urban Series, Инструкции и иллюстрации

Страница: 17 / 25

17
ASSEMBLY OF GREENHOUSE UNIT
The first operation is to connect the two side frames to the two end frames to form the outer shape of the completed structure.
Another pair of willing hands would be useful at this stage.
1.
Lift the first side frame into its position by the rear end.
2.
Slot the eaves bar into the small space between the roof and side corner bar so that the gutter is outside the end frame
and the two flanges that form the angle of the roof and side are inside and tight up against the bolt slots of the roof and
side corner bar. (Key point).
3.
The extra bolts that were inserted in the bolt slots during the gable end assembly can now be used.
4.
Line up the elongated holes in the flanges of the eaves with the bolt slots and slide the bolts into them. Put a nut on the
top bolt and tighten up. Place the diagonal side angle onto the bottom bolt, put a nut on and tighten up. (Key point).
5.
The bottom cill or build in base attaches to the inside of the corner bar. The bolt placed in the corner bar bolt slot at
gable end assembly will slide down into the slotted hole at the end of the cill. For the built in base model the base leg
attached at frame assembly can now be attached to the gable end, in a similar way to its attachment to the side frame.
6.
Do the same at the other three corners.
7. Slide the beading into the ridge into the two V slots, and then attach the ridge to the roof corner bars by inserting the end
of the ridge through the small gap in the corner bars at the top. The vertical part of the ridge will be outside and pointing
skywards and the two flanges that form the angle of the roof will be inside, tight up against the bolt slots of the roof
corner bars.
8.
Line up the slotted holes at the end of the ridge with the bolt slots, in the corner bars and push the two bolts, previously
inserted during gable end assembly, into the slots. Put on nut and tighten.