Redpath Urban Series, Инструкции и иллюстрации

Страница: 13 / 25

13
DOOR FRAME ASSEMBLY
Components consist of:
2x door glazing bars (1x handed, 1x unhanded)
3x infill panels
2x top & bottom door panels
From the main bag of fittings you require:
2x door wheels
2x clip on nylon door skids
2x lengths of black rubber draught excluder
Self-tapping screws and spring washers.
1.
Place the two sidebars on a level surface roughly two feet apart with the bolt slots facing downwards. The top of each
sidepiece has two screw holes in it, the bottom has three (Key point). Slide the glazing beading into the V grooves that face
inwards toward the door panels. (Not in the outside V groove).
2.
Place the top, bottom and three infill panels in position as shown by the position of the screw holes in the sidepieces and
the panels. The top panel has the greenhouse name on it. The bottom panel has the edge for the door skids to fit on. The
lower infill panel locks on to the bottom panel. (The flat part of the panels face uppermost).
3.
Fix the door together by screwing through the sidepieces into the holes provided in the edge of the panels with the No.8
half-inch self-tapping screws. Do NOT fix the top left hand side screw yet. The screws will go in more easily and without
danger of trying to go crooked if you can put a small amount of grease on the screw before assembling the doors.
Alternatively, you could insert the screws into the screw eyes of the door panels before assembling the door; this would
have the effect of pre-self tapping the panels prior to assembly making assembly easier.
4.
Fix the top left hand side with the longer screw provided. Put the screw through the door catch so that the serrated part is
facing outwards and upwards. Next slip tow spring washers on to the screw, and then fix the screw through the side of the
door and into the top panel. (Key point).
5.
Make sure all the angles are square and tighten all screws.
6.
Fix each door wheel into position by pushing the bolt provided through the centre of the wheel and then through the hole
in the top door panel from underneath (i.e. from the inside of the door). Put the washer over the bolt and secure with the
nut provided, tightening until there is no movement on the bolt. The nuts are lock nuts and are harder to put on than the
normal nuts in general assembly. The wheel will revolve freely because it has ball bearings in it.
7.
Slip the nylon door skids on each end of the bottom panel.
8.
Turn the door over and insert the black rubber draught excluders in the groove 9bolt slot) in each sidepiece of the door.
Push up to the top of the door and trim off the surplus as the bottom. With a pair of pliers squeeze the groove together at
the bottom so that the rubber will not slip down when the door is in its upright position.
9.
Do not fit the door at this stage.