Redpath Urban Series, Инструкции и иллюстрации

Страница: 11 / 25

11
DOOR END ASSEMBLY
Components:
1x Door End Cill or Built in Base; 2x Glazing Bars; 2x Short Horizontal Braces;
2x Roof Corner Bars (marked ‘R’); 2x Side Corner Bars (unmarked); 1x Door Track Support;
1x Door Track (top); 1x Door Track Angle Stay, (Small Door Track Support).
From the main bag of fittings you will require the nuts and bolts.
You will also require 2x Eave Plates and 1x Ridge Plate. These are packed with the casement stay and are
separate from the main bag of fittings.
INSTRUCTIONS
1.
Assemble the frame in exactly the same way as the rear end, up to and including stage 5 of the rear end, but add one extra
bolt into each bolt slot of the end glazing bars.
2. Attach the main door track support (shaped like a letter ‘Z’ to be found with the door panels) to the two glazing bars around
6” down the bar as shown. This ‘Z’ shaped bar must be fitted with the two outside slots facing upwards (as illustrated) not
downwards.
3.
The two short horizontal braces attach to the top bolt in the gusset plate and the vertical glazing bars.
4.
Stand the frame up and fix the small angle door track support to the right hand side corner bar (viewed from outside). See
front of assembly.
5.
Bolt the door track to the main door track support and the door track support angle stay by inserting 4 bolts into the bolt
slot of the door track. Position these through the 3 holes in the door track support above the door opening and the upper
hole of the small angle door track support. When this has been achieved tighten all nuts.
Please note, you only require approx. 200mm of beading in the inside ‘v’ groove of the two end glazing bars.
N.B. Please note carefully the correct position of the main door track support.
The slotted holes at either end are facing skywards not downwards.
At a later stage, when the top door track has been attached, the precise height and position of the track and support can be
established.