10
STEP 2: Install the Display Face and Push-Buttons
First, plug the push-buttons into the Redondo display face.
Be careful not to damage the plug or wires when plugging in the
push-buttons. Next, plug the ribbon cable connected to the Motor
3 radio body into the display face. After plugging in the display
face and push-buttons, attach them to the InfiniMount control face
brackets (see Figure 2).
NOTE: You can tell which side is the top of the Display Face by looking at the location
of the lens. There will be more space beneath the lens on the Display Face than at
the top (see Figure 2).
Before tightening the screws, adjust the display and push-buttons
to match the factory radio opening. For best results, measure the
factory radio opening or use the original factory radio for reference.
Once they are aligned and in adjustment, tighten the screws.
Finally, install the lens into the display face by lining up the notches
on the lens with the slots on the display face and snapping it into place.
INSTALLATION INSTRUCTIONS
Figure 2 - Attach Redondo Display Face
and Push-Buttons
Lens
Display Face
Push-Buttons
