9
The patented InfiniMount
adjustable system allows almost unlimited
installation options with independently adjustable controls to
accommodate your needs.
To begin, locate the two shafts or thumb-rollers, two InfiniMount
brackets, two InfiniMount control face brackets and the mounting
screws. If you have a Redondo RS, locate the two large washers and
two small washers inside the mounting hardware kit packaged with
your shafts (see “What’s in the Box” on page 4 and 5).
STEP 1: Install InfiniMount
Control Face Brackets
First attach the InfiniMount control face brackets to the front of the
radio body by sliding them into the slots on the side of the radio and
securing them with the four small screws that came in your kit. They
can be installed on either side with the extra mounting section at the
top or bottom depending on fitment for your vehicle. You can cut this
piece off if you need to (see Figure 1). The rear edge of this bracket
is bent so that the display face and push-buttons can attach to the
front of the radio. Make sure the brackets bend inward towards the
center of the radio.
*For most applications, you will need to cut this part off with tin snips or a rotary cutting
tool by cutting along the perforated line (see Figure 1). This will NOT void your warranty.
INSTALLATION INSTRUCTIONS
Figure 1 - Attach InfiniMount
Control Face Brackets
Extra Mounting
Section
InfiniMount Control
Face Bracket
Cut on Perforated Line (if necessary*)
