Redmond SkyCooker RMC-M92S, Руководство пользователя

Страница: 11 / 16

SkyCooker RMC-M92S
11
Time Delay Function
This function allows setting the program to finish by certain time. Cooking time may be delayed for
a period from 10 minutes to 24 hours with 10 minute intervals. Setting Time Delay function, take the
cooking time of the program into consideration. The time of a delay should be longer than the cooking
time of the program selected; otherwise the program starts running right after you press “Старт”.
To set the time of delay press the “Отложенный старт” button after the program selection. To
increase the hour value press the “Час” button, to increase the minute value – the “Мин” button.
Press and hold the corresponding button down to scroll through the digits.
Time Delay function is available in all automatic programs except “ЖАРКА”, “МАКАРОНЫ” and
“ЭКСПРЕСС”.
It is not recommended to use Time Delay function if dairy and other perishable products are
being used (eggs, fresh milk, meat, cheese etc.).
Keep Warm Function
Function is being automatically activated at the end of the cooking program. When the program
finishes, the temperature of the meal (70–75°C) is being maintained for a period of time up
to 12 hours. The Reheat/Cancel indicator is lit with the enabled Keep Warm, the direct counting
of the program time in this mode is displayed.
Keep Warm may be disabled if necessary by pressing and holding the “Отмена/Разогрев” button
until an audible signal is heard.
The function is not applicable in “МАКАРОНЫ”, “ЙОГУРТ” and “ЭКСПРЕСС” programs.
When setting the cooking temperature below 80°C in the “МУЛЬТИПОВАР” program the Keep
Warm function will be disabled by default. To enable Keep Warm press and hold down the “Меню”
button during program operation.
Disabling The Keep Warm In Advance
Automatic activation of the Keep Warm function at the end of the program may sometimes be
undesirable. The multicooker allows disabling the function in advance, while setting the
program or during its operation. Press and hold down the “Меню” button to cancel the function.
“Отмена/Разогрев” button indicator goes off. To reactivate the function, repress and hold down
the “Меню” button (“Отмена/Разогрев” button indicator goes off).
Reheat Function
The multicooker can be used for warming up cold meals. To reheat:
1. Put the products into the bowl. Place the bowl inside the device.
2. Close the lid until it clicks into place and plug in the unit.
3. Press and hold down “Отмена/Разогрев” button for a few seconds until an audible sound
is produced. Corresponding indicators light up and reheating process begins. The timer
starts its countdown.
The meal will be warmed up to 70–75°C and the temperature will be maintained for the next
12 hours. To cancel the function press and hold down “Отмена/Разогрев” button. Corresponding
indicators go off.
The function may operate for a period of 12 hours, however, we recommend using it moderately,
because a prolonged thermal exposure may sometimes affect flavor characteristics of the meal.
Standard Operating Procedure for Automatic Programs
IMPORTANT! When using the water boiling device (for example, when boiling products), DO NOT
set the cooking temperature above 100°C. It may result in overheating and failure of the device.
For the same reason, DO NOT use the “ВЫПЕЧКА”, “ЖАРКА” and “ХЛЕБ” programs to boil water.
1. Measure the ingredients according to the recipe.
2. Put them into the bowl. Make sure that all the ingredients including liquid are below the
scale mark indicating maximum capacity. Place the bowl inside the device. The bowl and
the heating element must fit tightly.
Use only the bowl supplied or compatible with this model when using the multicooker. See www.
redmond.company for compatible bowls. DO NOT use any other utensils!
DO NOT process food directly in the bowl! This may damage the non-stick coating, deform the
bowl and damage the appliance.
3. Close the lid until it clicks into place. Plug in the unit.
ATTENTION! If you cook at high temperatures using a large amount of vegetable oil, always
leave the lid of the device open.
4. Repeatedly press “Меню” button to select the program (corresponding indicator lights up).
To start the “ЭКСПРЕСС” program from the standby mode press and hold down the “Экспресс”
button, until the “ЭКСПРЕСС” indicator lights up on display. During this program operation the
program countdown is not displayed.
5. The “МУЛЬТИПОВАР” program provides the cooking temperature adjustment before the
start of the program (default temperature is 100°С). Set the desired value by pressing the
“Температура” button.
6. You can adjust cooking time value.
7. Set time of delay if necessary.
8. Press and hold for several seconds the “Старт” button to begin cooking cycle. Start and
Reheat/Cancel indicators will light up solid. Depending on the selected cooking program
the countdown will start immediately or after water in the bowl comes to the boil.
When using the “МАКАРОНЫ” program an audible signal will inform you of water boiling and
the necessity of adding the ingredients. The time starts to countdown after repressing “Старт”.
9. To preliminarily disable the Keep Warm function, press and hold down the “Меню” button
(the (“Отмена/Разогрев” button indicator will go out). You may re-enable this function by
repressing the “Меню” button.
10. An audible signal will be produced to indicate that cooking cycle is complete. Depending
on selected programme or current settings the appliance will either enter Keep Warm
(Reheat/Cancel is lit on the display) or Standby mode “Старт” button indicator is flashing).