RedMax 967683802, Руководство по ремонту

Страница: 16 / 50

16 – English
Safety equipment
7.1.4 Function check
For this test, the engine must not be running. Check
that the chain brake cuts in as follows:
1. Hold the chain saw over a stable surface as
shown in fig. 10. The distance between the bar
and surface is given in the table below.
Bar length, L Height, H
18-20 inches
21-28 inches
50 cm
70 cm
2. Let go of the front hand grip and let the
chainsaw pivot round on the rear hand grip.
3. 3. When the bar hits the surface the chain brake
should cut in.
7.1.5 Chain catcher
Dismantle the chain and bar. See instruction book.
Inspect the chain catcher and replace it if it is dam-
aged. The bolts should be tightened to 6 Nm. See
fig. 11.
Fit the chain and bar. See instruction book.
WARNING!
After repair, the chain brake must
be checked according to the
following instructions.
Fig. 10
L
H
Fig. 11