RDL-2000
User Manual
70-00143-01-01a
Proprietary Redline Communications © 2010
Page 8 of 50 September 20, 2010
4.
Provide direct grounding from the unit, the mounting bracket, the antenna, and the
Ethernet cable surge protection to the same ground bus on the building. Use the
grounding screws provided for terminating the ground wires.
1.5 FCC and IC Notices (USA & Canada)
1.
The Model RDL-2000 and its antenna must be professionally installed.
2.
WARNING -- FCC & IC RF Exposure Warnings
To satisfy FCC and IC RF exposure requirements for RF transmitting devices, the
following distances should be maintained between the antenna of this device and
persons during device operation:
Table 1
:
Notices
:
FCC & IC RF Recommended Safe Separation Distances
Frequency (GHz)
Mode
Separation Distance
5.4 Band
PTP
40 cm (16 in) or more
5.8 Band
PTP
354 cm (140 in) or more
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
3.
High power radars are allocated as primary users (meaning they have priority) of
5.650 - 5.850 GHz and these radars could cause interference and/or damage to LE-
LAN devices.
4.
FCC Information to Users @ FCC 15.105:
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Where DFS is required by regional regulations, this function is permanently enabled
at the factory and can not be disabled by the installer or end-user.
5.
FCC Information to Users @ FCC 15.21:
Warning: Changes or modifications not expressly approved by Redline
Communications could void the user‟s authority to operate the equipment.
