- 4 -
H1500
SAFETY REGULATIONS
The
RINK – Roller Spreader H1500
is exclusively designed for spreading fine-grain,
loose gritting material such as sand, gravel, rubber granules or similar.
Any other use is considered to be improper. The manufacturer is not liable for any
damages incurred as a result. The risk is borne solely by the user.
The intended use also includes strict compliance with the operating, maintenance and
repair requirements specified by the manufacturer.
The
RINK – Roller Spreader H1500
has been constructed using state-of-the-art
technology and is safe to operate. However, the
RINK – Roller Spreader H1500
may
pose dangers to a user’s or another person’s life and limb if the machine is not used,
maintained and repaired by authorized persons who are familiar with it and have been
instructed in the hazards involved.
Any person in the operator's company who has been commissioned to operate, service
and repair the spreader must have read and understood the operating instructions and, in
particular, the section
Safety Regulations
.
Use
only
original manufacturer spare parts
for repairs.
Besides the instructions contained in this operating manual, the general
safety and
accident prevention regulations
are to be observed.
The
RINK – Roller Spreader H1500
may
travel on public roads
when a lighting system
is installed.
Transportation of persons is not permitted !
Keep off the loading bridge whilst the spreader is running.
A corresponding notice
has been affixed on both sides of the
RINK – Roller Spreader H1500
. These notices
must always be legible and must be replaced when damaged. (See Spare Parts)
The operator is
obliged
to inspect the
RINK – Roller Spreader H1500
for
visible signs
of damage and defects
before operating the machine. Any changes to the
RINK -
Roller Spreader H1500
(including to its operation), which may have a negative impact on
safety, must be rectified immediately. For safety reasons, it is strictly prohibited to make
any changes or additions to the
RINK – Roller Spreader
(except for changes/additions
which have been approved by the manufacturer). If any modifications to the
RINK -
Roller Spreader H1500
are carried out, the CE marking currently valid for the machine
will become invalid. The person who has made these modifications will be responsible to
independently apply for the renewal of the CE marking.
