REDEX MSR 330, Руководство пользователя

Страница: 7 / 40

2 SPEED GEARBOX
User manual
Ref.: RX142/046
Version 09/05/2017 - English
This document must not be reproduced nor information therein disclosed without our authorization
Page 7 / 35
3.2.1 "A" input flange code (input sun gear without seal, without bearing)
MSRXXX . A H 5 S . 2076 M2 . 21J42 . D . SS
A. Put the motor horizontally on a table
B. Clean and degrease the motor shaft and the bore of the MSR input sungear
C. Adjust the key to the input sungear keyway and to the motor shaft keyway
D. Lightly grease the motor shaft using an anti-fretting paste
E. If a spacer is delivered with the gearbox, Fit it on the motor shaft against the shaft shoulder
F. Fit the key on the shaft
G. Heat the input sungear up to 80-100°C
H. Fit the input sungear against the spacer or the shoulder according to the sketch.
I. Measure the length X
2
between the motor mounting surface and the input sun gear as shown
on the picture below.
J. Measure the length X
1
between the output sun gear bearing and the MSR motor flange
mounting surface, as shown in the picture below.
WARNING!
NEVER REMOVE THE SNAP RING OR THE PLUG WHICH IS INSIDE
THE BORE OF THE SUN GEAR .