REDEX MSR 330, Руководство пользователя

Страница: 10 / 40

2 SPEED GEARBOX
User manual
Ref.: RX142/046
Version 09/05/2017 - English
This document must not be reproduced nor information therein disclosed without our authorization
Page 10 / 35
3.2.3 "E" input flange code (input sun gear with seal, without bearing)
MSRXXX . E H 5 S . 2076 M2 . 21J42 . D . SS
A. Put the motor horizontally on a table
B. Clean and degrease the motor shaft and the bore of the MSR input sun gear
C. Adjust the key to the input sun gear keyway and to the motor shaft keyway
D. Lightly grease the motor shaft using an anti-fretting paste
E. If a spacer is delivered with the gearbox, Fit it on the motor shaft against the shaft shoulder
F. Bring the sealing flange with his seal onto the motor
G. Fit the key on the shaft
H. Heat the input sun gear up to 80-100°C
I. Fit the input sun gear against the spacer or the shoulder according to the sketch.
J. Measure the length X
2
between the motor mounting surface and the input sun gear as shown
on the picture below.
WARNING!
Avoid damaging the lip of the seal during this operation!