REDEKOP Case IH AFX 120 Series, Руководство по установке

Страница: 104 / 109

104
15 Software Update
15.1 Update software:
Use the 240-Series EST to set the new configurations on 230-Series and 240-Series machines.
(after the S/N break below)
The new cab machines start at S/N YDG218540
Software update required is: UCM1 - V33.33.0.0 or newer, UCM2 - V33.34.0.0 or newer (for S/N above and newer)
Display Software (Part # 48109497 Combine Axial Flow) V30.8.0.0
Machines <YDG218540 do not get software update and would require the spreader/chopper speed sensor placed on
the 7-tooth target.
15.1.2 Use EST to change the Machine Configuration for “Residue System.”
15.1.3 Set configuration to:
Configuration Name Type ID Value
Residue System Windrow* 0x209C
Residue System Non Windrow* 0x209C None
Windrow Door 0x20A1 1 (installed)
Left Spread Deflector 0x2112 1 (installed)
Center Spread Deflector 0x2113 0 (not installed)
Right Spread Deflector 0x2114 1 (installed)
Hood Mount Chopper 0x2111 1 (installed)
Windrow Chute Extension 0x20A4 0 (not installed)
*For MY14 and newer machines with existing 90cc spreader motor and 32cc pump with in cab adjust, Value = 6
*For MY13 UCM machines with existing 74cc spreader motor and 28cc pump, Value = 3
*Note - Installing a Windrow Chopper on a Combine with a Beater; will require a Speed Sensor and Bracket to be
installed. This is required to calibrate the Straw Door Actuator.
15.2 Calibrate the windrow door and spread control actuators following the instructions in the Owner’s Manual
Impeller with 32cc Pump &
90cc Motor In-CAB Adjust
30 and 40 Series