FLAME EFFECT
The flame effect is created with the use of a 40 watt B-10 candelabra light bulb with
an E-12 (small) socket base. The light bulb will have to be replaced from time to
time when it burns out.
During normal operation, the stove heater will always give you simulated flame
function. If the intensity of flame suddenly increases, it means that the light bulb is
going to burn out.
Replace the light bulb immediately, according to the instructions below. Do not
operate the stove heater when the light bulb burns out or without the light bulb.
Doing so will void the warranty.
CHANGING THE LIGHT BULB
1.
Open the door of unit with the handle.
2.
Loosen the two screws at the front of the log set inside the stove. Carefully lift
the log set up far enough to access the light bulbs. You will find 1 X 40W Type
B-10 candelabra light bulb with E-12 socket base at the bottom.
3.
Replace burned out light bulb using new 40 watt Type B-10 candelabra light bulb
.
4.
Reinstall the logset.
5.
Plug in the unit.
