OPERATING INSTRUCTIONS
Setup Modes
Pressure Warning Level
Mode / Beeps:
7
Selections:
0psi-35psi
Press and hold to slowly increase the pressure reading until it reaches the desired
warning level.
Relay Output
Mode / Beeps:
8
Selections:
‘+’/‘-’ for above/below, pointers/levels
Press and hold the programming button to cycle through which warning will trigger
the relay output. A number on the display indicates that the Optional Pressure Sensor
warning will trigger the relay. A pointer indicates that that reading will trigger the
relay. After each cycle, under(-) or over(+) pressure mode is selected.
Note: Grey segment denotes a flashing portion of the Gauge screen during this mode of setup.
RECOMMENDED ACCESSORY: ENHANCED LIGHTING CONTROLLER (GA-ELC)
The REDARC Enhanced Lighting Controller is designed to enhance the lighting of your REDARC gauge. It
is to be used when you do not have a dimming circuit to connect your gauge to or the dimming circuit in
your vehicle does not dim the REDARC gauge to your liking.
The GA-ELC also allows you to program night time brightness and colour of your REDARC gauges,
including dimming if connected to a dash dimmer. Once programmed your gauges will change colour
when turning on your park lights and back to a day light colour when you turn them off.
The GA-ELC is also 24V capable and only one is required for a set of gauges.
Refer to
www.redarc.com.au
for more details.
PSI
EGT
X100
PSI
BOOST
3
5
7
4
6
0
10
20
30
7
PSI
EGT
X100
PSI
BOOST
3
5
7
4
6
0
10
20
30
