OPERATING INSTRUCTIONS
Selecting Gauge ID for multi-gauge systems
If your gauge is part of a multi gauge system (i.e. more than one gauge) and you wish to allow
programming from a single push button, connect the communication link wires together (see wiring
diagram on page 2). The Gauge “Id” of all linked gauges will need to be set to unique numbers.
Make sure that each gauge is set to a unique number or letter and that one gauge is set as the master
“Id.0”. The master gauge switch needs to be accessible for programming all the gauges. Each individual
gauge switch is only needed to set the programming ID.
Setup Instructions
Setup Mode is only required if you wish to change settings such as background color or other options. Setup
mode is indicated by the display of the programming symbol.
A detailed listing of the Setup Modes for the G52-BEP can be found on page 6.
To enter Setup Mode:
To view the next setting:
To change the setting & move to next mode:
To save all changes:
*Refer to “Selecting Gauge ID for multi-gauge systems”
at the top of this page
RELEASE
4
3
To access
all settings
To access
Gauge ID
Only*
2
HOLD
1
LO
CK
ACC O
N
ST
AR
T
OFF
Ignition
OFF
Parklight
OFF
Release to
select
Push & Hold
to Cycle
Push
(Momentary)
5
Push to Cycle
...
LO
CK
ACC O
N
ST
AR
T
OFF
Ignition
OFF
Parklight
OFF
