14 | Installation
2.3.2 MOUNTING THE REMOTE HEAD ON A DASH OR CONSOLE PANEL
Ensure that there is enough space behind the mounting location to fit the Tow‑Pro
®
control head
and remote head cable before drilling any holes.
Ø 3.5 mm (Ø1/8")
7.5 mm (0.3
")
Ø 10.0 mm (Ø 3/8")
(Drill pilot hole first or
use a spade bit)
2.0
–
3.0 mm
(0.08"
–
0.12")
1
Drill mounting holes.
2
Place bezel (optional) to cleaned surface.
0.8 Nm
(0.6 lbf-ft)
3
Insert Remote Head shaft through the
hole and fasten with nut.
4
Turn shaft fully anti‑clockwise.
Level marker
5
Apply knob with ‘0’ aligned to level
marker on the bezel.
6
Test installed remote head for
correct function.
CAUTION
Ensure the remote head push‑button activates correctly when installed into panels with a
thickness greater than 3.0 mm (0.12"). Failure to activate correctly would result in not being able
to activate the override function or change modes.
