Pub. 42004-545A
telephone VoIP WiFi Telephone Manual
Page 24 of 29
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-545A.docx
03/20
Heartbeat
The
HB
LED, located on the VoIP PCBA (see Figure 23), flashes when communication over the LAN is
established.
Link
The
L
NK
LED, located on the VoIP PCBA (see Figure 23), indicates an active network connection when
illuminated.
Speed
The
SP
LED, located on the VoIP PCBA, (see Figure 23) indicates a 100 Mbps network connection
when illuminated or a10 Mbps connection when off.
WiFi Activity (WiFi Units Only)
The WiFi Activity LED ,located on the WiFi module, turns ON when the VoIP telephone is powered, and
flashes when data is being transmitted (see Figure 23).
WiFi Ready (WiFi Units Only)
The WiFi
R
EADY
LED is a green LED, located on the RJ-45 connecter,
J2
, on the VoIP carrier PCBA. It
illuminates when the WiFi Interface is ready to connect to a wireless network (see Figure 23).
WiFi Connected (WiFi Units Only)
The WiFi
C
ONNECTED
LED is a yellow LED, located on the RJ-45 connecter,
J2
, on the VoIP carrier
PCBA. It illuminates when the WiFi Interface is connected to a wireless network or device (see Figure
23 for its location.
VoIP Circuit PCBA Pushbuttons
Reset
Press the
RESET
button (see Figure 23) momentarily to warm reboot the telephone. The telephone
maintains the current configuration.
Factory
Use the
FACTORY
button (see Figure 23) to erase the current configuration and restore the factory
default settings as follows:
1.
Press and release the
RESET
button.
2.
Press and hold the FACTORY button for 10 seconds while the telephone is rebooting.
The telephone will reboot again with the factory default settings configured.
WiFi Interface Pushbuttons
Reset Button
Press the
R
ESET
button to restart the WiFi interface module (see Figure 23).
