
DSMC POWER OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC
955-0038, REV-A | 13
MODULE AND ADAPTOR OPERATIONS
Use the instructions in this section to install and remove DSMC adaptor modules and power modules.
INSTALL THE MODULE ADAPTOR
In order to attach most DSMC power modules, a MODULE ADAPTOR or +1 ADAPTOR MODULE must be in-
stalled to the back of the camera BRAIN. These module adaptors are sold separately from DSMC modules.
WARNING:
DSMC modules and adaptors are NOT HOT SWAPPABLE, meaning you cannot remove or install the
modules while the camera is powered on. Before installing or removing modules, you MUST power down the
camera. Failure to do so may result in damage to the modules or DSMC that will not be covered under warranty.
REQUIRED TOOL:
T20 Torx driver
1. Power down the camera.
2. Remove the REDMOTE, if attached.
3. Place the MODULE ADAPTOR over the V-mount on the rear of the camera BRAIN.
4. Use a T20 Torx driver to tighten the four (4) captive screws. Tighten screws in a cross pattern approximately
two turns each. DO NOT FULLY TIGHTEN.
5. Fully tighten the four (4) screws in a cross pattern. DO NOT OVERTIGHTEN.
MODULE ADAPTOR Installation
Tighten screws in an “X” pattern