R
EVISED
2016-01-19
OutDiscards
DINT
Outbound packets discarded
OutErrors
DINT
Outbound packets that contain errors
Alignment_Errors
DINT
Frames received that are not an integral
number of octets in length
FCS_Errors
DINT
Frames received that do not pass the
FCS check
Single_Collisions
DINT
Successfully transmitted frames which
experienced exactly one collision
Multiple_Collisions
DINT
Successfully transmitted frames which
experienced more than one collision
SQE_Test_Errors
DINT
Number of times SQE test error
message is generated
Deferred_Transmissions
DINT
Frames for which first transmission
attempt is delayed because the medium
is busy
Late_Collisions
DINT
Number of times a collision is detected
later than 512 bit- times into the
transmission of a packet
Excessive_Collisions
DINT
Frames for which transmission fails due
to excessive collisions
MAC_Transmit_Errors
DINT
Frames for which transmission fails due
to an internal MAC sub layer transmit
error
Carrier_Sense_Errors
DINT
Times that the carrier sense condition
was lost or never asserted when
attempting to transmit a frame
Frame_Too_Long
DINT
Frames received that exceed the
maximum permitted frame size
MAC_Receive_Errors
DINT
Frames for which reception on an
interface fails due to an internal MAC
sub layer receive error
Control_Bits
INT
0 Auto-negotiate 0 indicates 802.3 link
auto-negotiation is disabled. 1 indicates
auto-negotiation is enabled. If auto-
negotiation is disabled, then the device
shall use the settings indicated by the
Forced Duplex Mode and Forced
Interface Speed bits; 1 Forced Duplex
Mode If the Auto-negotiate bit is 0, the
Forced Duplex Mode bit indicates
whether the interface shall operate in
full or half duplex mode. 0 indicates the
interface duplex should be half duplex.
1 indicates the interface duplex
Forced_Interface_Speed
INT
Speed at which the interface shall be
forced to operate. Speed in Mbps (10,
100, 1000, etc.)
N-Tron® Series 700/7000 Switch CIP™ Manual
-32-