Red Hat NETWORK SATELLITE 5.3.0 - CHANNEL MANAGEMENT, Справочное руководство

Страница: 203 / 318

Working With Your Virtual Systems
191
Tip
You may receive the following message from the
Kickstart Status
page during
the guest's kickstart:
The install process on the guest system has not communicated to
RHN in
the past n minutes. This may be due to a hung install process,
or it
may just be due to a slow install because of hardware
constraints. A
log of the installation process is available, you may wish to
review
it to troubleshoot this issue.
Be patient and do not worry if you see this message unless more than twenty minutes
have passed. To check if the kickstart is continuing, check the installation log to make
sure there are no errors, and as you reload the Kickstart Status page check to see
that the Last File Request field continues to be updated.
4. If you would like to register additional guests to your host, repeat the steps above. It is important
to remember that you can only provision one guest at a time. If you attempt to schedule a guest
kickstart while another is currently taking place, the current guest kickstart process will be
canceled and the new guest kickstart process will begin.
5. View your newly-created virtual guest's system in the Satellite's web interface by clicking on
the
Virtualization
tab in the host system's profile. Then, click on the profile name of your virtual
system. You will be brought to its Satellite system profile.
10.3. Working With Your Virtual Systems
Once you have set up your virtual system, you can then manage and customize them via various
methods, including connecting via SSH and via the virtualization management interface on the host
system.
10.3.1. Logging into Virtual Systems Directly via SSH
1. You will need to locate the virtual system's IP address. Locate it by navigating to the
Systems
�
Virtual Systems
tab and clicking on the virtual system's profile name.
2. On the virtual system's profile page, you'll find the IP address in the left-hand informational column
in the
IP Address
field.
3. Connect to the IP address by using
ssh
as root, using the password you set for the virtual system
in the kickstart profile you created for it earlier.