Red Hat LINUX ES 2.1 -, Руководство по установке

Страница: 33 / 110

Chapter 3. Installing Red Hat Enterprise Linux ES 23
Caution
If you have a RAID card, be aware that some BIOSes do not support booting from the RAID card. In
cases such as these, the
/boot
partition must be created on a partition outside of the RAID array,
such as on a separate hard drive. An internal hard drive is necessary to use for partition creation with
problematic RAID cards.
If you have chosen to automatically partition your system, you should select
Review and manually
edit your
/boot
partition.
To review and make any necessary changes to the partitions created by automatic partitioning, select
the Review option. After selecting Review and clicking Next to move forward, you will see the par-
titions created for you in
Disk Druid
. You will also be able to make modifications to these partitions
if they do not meet your needs.
Click
Next
once you have made your selections to proceed.
3.12. Partitioning Your System
If you chose automatic partitioning and did not select
Review
, please skip ahead to Section 3.16.
If you chose automatic partitioning and selected Review , you can either accept the current partition
settings (click
Next
), or modify the setup using Disk Druid, the manual partitioning tool.
If you chose Manually partition with fdisk , please skip ahead to Section 3.13.
At this point, you must tell the installation program where to install Red Hat Enterprise Linux ES.
This is done by defining mount points for one or more disk partitions in which Red Hat Enterprise
Linux ES will be installed. You may also need to create and/or delete partitions at this time (refer to
Figure 3-7).
Note
If you have not yet planned how you will set up your partitions, refer to Appendix D. At a bare mini-
mum, you need an appropriately-sized root partition, and a swap partition equal to twice the amount
of RAM you have on the system.