Record Power TS250C, Оригинальное руководство пользователя

Страница: 11 / 36

11
11
1
2
3
4 5
7
6
8
9
10
12
13
14
1. Sliding table
2. Back panel
3. Left panel
4. Front panel
5. Right panel
6. Scale
7. Front rail
8. Rip fence Seat
9. Rip fence
10. Extension table
11. Extraction hose support
12. Main saw unit
13. Blade guard
14. Rear extension table
Noise Levels
The measurements of noise, in the working position and during operation,
were carried out under the standard ISO 7960 annex “J”:
Instantaneous acoustic pressure:
Sound power level (no load) <90dB(A)
Sound power level (load) <100dB(A)
Sound pressure level (no load) <80dB(A)
Sound pressure level (load) <90dB(A)
The figures quoted are emission levels and are not necessarily safe working
levels. Whilst there is a correlation between the emission and exposure
levels, this cannot be used reliably to determine whether or not further
precautions are required. Factors that influence the actual level of exposure
of the workforce include the characteristics of the work room and the
other sources of noise etc. i.e. the number of machines and other adjacent
processes. Also the permissible exposure level can vary from country to
country. This information, however, will enable the user of the machine to
make a better evaluation of the hazard and risk.
Dust Collection
Proper dust extraction eliminates the risks of dust inhalation and aids better
functioning of the machine.
The table lists the minimum air flow and speed values referenced to each
single extraction operation.
Ensure that the extraction system to be used guarantees these values at the
connection point,
Fig 4.2
.
Suction mouth diameter ( Fig 4.2 ):
A - Crown (blade) guard ø 30 mm
B - Lower Extraction Port ø 100 mm
Connection to the extraction system should be made with flexible hoses of
adequate diameter and secured with hose clips.
The extraction hose must be positioned in such a way so as not to obstruct
the operator during machining.
Please note: Always work with the extraction system connected
and switched on. Always start the extraction system at the same
time as the circular saw. It is advisable to leave the extraction
system running for a few seconds longer than the circular
saw in order to fully clear any residual waste remaining in the
extraction hose.
Upper hood Lower hood
Air flow 140 cu.m/h 690 cu.m/h
Saw
Minimum air speed 20 m/s
Saw
Upper hood Lower hood
Air flow 140 cu.m/h 690 cu.m/h
Maximum air speed 20m/s
i
Kg
i
Kg
4. Saw Unit Assembly