25
9. Maintenance
Changing the blade
1. To change the blade; first remove the crown
guard by slackening off the locking screw and
unhooking from the riving knife
Fig.9.1
.
2. Loosen the 3 screws on the table insert
Fig.9.3
and remove the insert.
3. Remove the sliding table stop and remove the
sliding table
Fig.9.2A/9.2B
to give access to
the extraction panel. Loosen the holding screw
on the extraction panel and pull the panel away
from the blade to create a space between them
Fig.9.5
.
4. Place the tommy bar in the location hole
behind the blade
Fig.9.7
.
5. Using a spanner, turn the nut clockwise to
loosen it. At this point the tommy bar should
have turned with the blade and be tight up
against the spindle housing creating an anchor
to turn against
Fig.9.4
.
6. Remove the nut, washer and bush from the
blade spindle
Fig.9.6
.
Please note: Take care not to drop the
nut down into the unit.
7. It is now possible to remove the blade from
the spindle
Fig.9.7
.
The blade can now be replaced.
8. Feed the new blade on to the spindle ensuring
that it is seated firmly on the hub.
9. Replace the bush, washer and nut and using
a spanner, turn the nut anti-clockwise to tighten
it. At this point the tommy bar should have
turned with the blade and be tight up against
the spindle housing to create an anchor to turn
against.
10. Replace the extraction panel and secure with
the fixing screws.
11. Replace the table insert and retighten the
screws to hold it in place.
12. Re-fit the sliding table and secure by fitting
the sliding table stop.
Fig.9.1
Fig.9.2A
Fig.9.2B
Fig.9.3
Fig.9.5
Fig.9.6
Fig.9.7
Fig.9.4
Locking screw
Caution:
Before carrying out any adjustment or
maintenance ensure that the machine
is isolated and disconnected from the
electricty supply. Saw blade has teeth that
are sharp always wear protective gloves
when handling the blade.
Note:
The retaining nut for the blade uses
a left hand thread and works in the
opposite direction to a conventional
thread pattern. Turn the nut clockwise to
loosen and anti-clockwise to tighten.
i
Kg
i
Kg
i
Kg
i
Kg
Содержание TS250C
Страница 28: ...28 11 Parts Lists Diagrams ...
Страница 29: ...29 11 Parts Lists Diagrams cont ...
Страница 30: ...30 11 Parts Lists Diagrams cont ...
Страница 31: ...31 11 Parts Lists Diagrams cont ...
