Record Power PT260, Руководство по эксплуатации и инструкции по обслуживанию

Страница: 24 / 41

3. To protect the infeed table from scratches, partially cover the sharpening stone with paper
(Figure 22).
4. Lay the stone on the infeed table.
5. Lower the infeed table and turn the cutterhead by turning the cutterhead pulley.
The infeed table height is set properly when the stone's surface is flush with the knife bevel.
6. Keep the cutterhead from rotating by grasping the cutterhead pulley while sliding
the stone back and forth across the table.
7. Take the same amount of passes for all three blades.
When the blades have been sharpened and still are not cutting efficiently, trying to touch up the
blades further will only cause the formation of a second beveled edge. When this starts to happen,
it is time to replace blades with another set. It is recommended to keep a second set of blades on
hand so that they may be installed
while the first set is being professionally sharpened.
Lubrication
Use a good grade of light grease on the steel adjusting screws located in the raising and
lowering mechanisms of the work tables.
The cutterhead ball bearings are lifetime lubricated and need no further care.