Record Power PT260, Руководство по эксплуатации и инструкции по обслуживанию

Страница: 15 / 41

Setting Cutterhead Knives
Important :
Before performing any adjustments in this section, the infeed and outfeed tables must
be coplanar.
Cutterhead knives are dangerously sharp! Use extreme caution when inspecting, removing,
sharpening or replacing knives into the cutterhead. Failure to comply
may cause serious injury
1. Disconnect machine from the power source.
2. Remove the cutterhead guard (B, Fig. 8). Referring to
Figures 11 and 12:
3. Carefully number each knife blade (C) with a magic
marker to differentiate each.
Note:
To rotate the cutterhead the cutterhead pulley
must be turned. This requires removing the panel on the
back of the cabinet for access.
4. Rotate the cutterhead (E) and determine the 12 o'clock
position of knife number one. The 12 o'clock position is
the highest point a blade will reach in the cutting arc (C,
Fig. 12).
5. Set a straightedge (J) on the outfeed table (F) near the
fence (H). One end of the straightedge should be
positioned over the cutting knife (C) near the end of the
blade as shown in Fig. 9.
Use care when handling the straightedge near the blades to prevent damage.
Note the position of the knife blade with respect to the straightedge, then move the
straightedge to the other side of the table and again note the position of the knife blade with
respect to the straight-edge. Blade number one must be at the same height at each end and must
also be at the same height as the outfeed table (bottom of straightedge). If this is not the case,
adjustment is required as follows:
6. Slightly loosen five gib lock screws (A) by turning into the lock bar (B), clockwise as viewed from