HandPunch 3000/4000 Operations and User’s manual
5
Supervisor Enrollment
The first command you will use is ENROLLMENT. It is the process of recording your ID
number with the description of your hand in the hand reader’s memory. To enroll, you will:
1. Access the command mode using the keypad by pressing CLEAR and ENTER at
the same time.
2. Go to the ENROLLMENT mode by pressing the enrollment password (4) and
ENTER.
3. Enter your ID number and place your hand on the platen. The LCD and LED
displays will guide you through the process. You will place your hand on the platen
at least three times during enrollment.
A correct enrollment makes using the hand reader easy and trouble free. Practice the
following techniques before enrolling.
CORRECT HAND PLACEMENT RULES
1. Think of landing your hand on the reader like landing a airplane. Slide your hand
forward on the platen surface, until the web post between the middle and index finger
stops you. Keep your hand flat so that you feel the surface of the platen on the
underside of your fingers.
2. Close your fingers together so that each finger touches a guide pin. The red finger pin
lights go out when your fingers touch the guide pins. If a light stays on, just move that
finger until it touches the guide pin.
3. If you wear a ring, be sure the stone is facing up in the normal position.
The instructions in this manual show the LCD display message in the left column and the
keypad entry in the right column.
DISPLAY KEYPAD ENTRY
