HandPunch 3000/4000 Operations and User’s manual
4
Group 2,
Setup:
Supervisors with access to the SETUP menu can change the display
language, date format, time and date, reader address, ID length and the serial
communications baud rate. The time and date and ID length are normally set at the host
computer, however, the supervisor can change these parameters at the reader when the setup
is downloaded from the host computer.
Group 1,
Service:
Supervisors with access to the SERVICE menu can check and recalibrate
the reader, check the input and output status.
Passwords
Access to the Command Mode menus is controlled by passwords. Only the command choices
for the specific group entered will be available for use. When the unit is shipped from the
factory, the passwords are all set according to the table below. Once a system has been
installed, these passwords should be changed at the host computer.
SPECIAL GROUP
5
ENROLLMENT GROUP
4
MANAGEMENT GROUP
3
SETUP GROUP
2
SERVICE GROUP
1
Entering and Exiting the Command Mode
Press CLEAR and ENTER. The LCD will display ENTER PASSWORD. Enter the
appropriate command group password followed by ENTER. If the password is correct, the
display will present the command for the selected Group. If display returns to ENTER ID,
someone is enrolled in the reader database. If you are the system administrator and you are
denied access to the command group, it may be necessary to reset the user memory if the
enrolled person cannot be located. See page 19 for how to reset the memory.
Once you enter the Command Mode, the display will show one command at a time in the top
line. Shown in the second line will be the prompt.
* NO YES #
Pressing the # (yes) key will select the displayed command. Prompts will then appear as
appropriate for the selected command.
Pressing the * (no) key will cause the next command in turn to be displayed. Repeatedly
pressing the * key will scroll through the menus and eventually bring the display back to the
first displayed command.
When the *NO YES# prompt is shown on the display, pressing any number will exit the
Command Mode and return control to the Identity Verification Mode. The “
ENTER ID
”
display will reappear. This manual uses the number “5.”
