HandPunch 2000 Installation and Operations Manual
6
SUPERVISORS/ADMINISTRATORS OPERATING GUIDE
The HandPunch Command Mode is used to add and remove employees from the
system, and perform other system management and service operations. This section of
the manual describes those commands that will commonly be used by work group
supervisors in daily operations of the HandPunch. The command mode is only
accessible to people who are enrolled as supervisors.
Command Mode Overview
The command mode has five groups of menus. Access to each group is controlled by an
individual password.
COMMAND MODE STRUCTURE
SECURITY
DEFAULT
PASSWORD 5
ENROLLMENT
DEFAULT
PASSWORD 4
MANAGEMENT
DEFAULT
PASSWORD 3
SETUP
DEFAULT
PASSWORD 2
SERVICE
DEFAULT
PASSWORD 1
SPECIAL ENROLL
ADD EMPLOYEE
LIST EMPLOYEES
SET LANGUAGE
CALIBRATE
ADD SUPERVISOR
SET EMPLOYEE DATA
SET DATE FORMAT
STATUS DISPLAY
REMOVE EMPLOYEE
SET TIME & DATE
SET ADDRESS
SET ID LENGTH
SET SERIAL
Passwords
Access to the each command group requires a password. A new and unique password
can be assigned to each of the (5) Command Groups from the host computer. You must
exit one command group to enter another. The factory default passwords are shown in
the table below.
SPECIAL ENROLL GROUP 5
ENROLLMENT GROUP
4
MANAGEMENT GROUP
3
SETUP GROUP
2
SERVICE GROUP
1
