HandPunch 2000 Installation and Operations Manual
4
Installation
Select a location referring to the guidelines in the
installation planning section of this manual.
•
Measure 48-1/2 in. (123 cm.) to the finished
floor.
•
Drive a small nail into the wall or mark the
location.
•
Hang the wall plate from the hole located near
the top or tape it in place if necessary. Check to
ensure the wall plate is level.
•
Using the wall plate as a template, mark the
locations of the two holes near the top and three
holes at the bottom.
•
Remove the nail and wall plate from the wall.
•
For hollow walls, use the hardware provided to
fasten the wall plate to the wall. Use (2) furnished
auger style fasteners for the upper bolts and (3)
toggle bolts for the lower locations.
•
Drill the three lower bolt locations using a ¼
inch drill.
•
Install the auger style fasteners in the two upper
holes using a screwdriver. The auger will bore into
the wallboard. DO NOT OVERTIGHTEN.
•
Install the toggle bolts into the three lower bolt
locations. Tighten the bolt until you feel a strong
resistance. Do not over-tighten. Remove the bolts
and set them aside.
•
Hold the wall plate on the wall and install the
two upper bolts (2 inches inch long).
•
Install the bolts in the lower hole leaving
approximately 1/8 in. (3mm) clearance beneath the
screw heads.
•
See the next section for wiring details and the
completion of the mechanical installation.
•
Use expansion bolts (provided) for concrete
walls.
Mark location for the wall plate
