45
EN
V
A
CUUM SEALER
Troubleshooting
Trouble
Possible causes
Solutions
• The appliance
does not work
• Make sure that the ON(I)/
OFF(0) switch is on “I”
(ON).
The red light should be
on.
• The appliance will stop
automatically if overheat-
ed.
• Check for faults in the
power cord or the plug.
• Check the fuse.
• Positioning on ”I” the switch. Make
sure the power cord has been
plugged in properly. Check the
electric socket by plugging anoth-
er appliance into it.
• Allow it to cool down for 15 min-
utes and try again.
• Should you detect a fault, do not
use the appliance.
• If you need to replace it with an
identical type (250A). If the fuse
blows again contact technical
support.
• The appliance fails
to apply the first
seal on the bag cut
from the roll
• Make sure the bag cut
from the roll is properly
positioned (see instruc-
tions)
• The appliance
does not create a
complete vacuum
in the bags
• To seal the bag properly,
you must make sure that
the open end remains
completely inside the
vacuum chamber.
• The bag might have a
hole in it.
• Make sure that the sealing bar,
the sealing gaskets and airtight
gaskets are free of impurities.
After cleaning them, put them
properly back in place.
• To check the bag, seal it with air in-
side, place it underwater and ap-
ply pressure on it. The appearance
of bubbles means that there is a
leak. Reseal or use another bag.
N
