8
Installation
1. Connect the power cable, and then place any excess cable
in the cable compartment.
2. Place the charging base against the wall on a flat surface,
and then connect it to a power supply
3. Install the side brushes
4. Power on and charge
Align the left and right brushes with the corresponding markings
on the bottom cover. Press down until you hear a click, which
indicates successful installation.
Press and hold the button to turn on the device. Wait until the
indicator turns on, and then place the device on the charging
base.
Note: The device cannot start if it does not have enough battery power. Place the device on the
charging base, and it will automatically turn on when it has enough power. The device can
work normally only when the battery is ≥20% charged. As shown in the figure, the front of the
device should face the charging base so that the charging contact of the robot is touching
the wireless power receiver. The distance between the front of the device and the charging
base should be around 2 cm.
Note:
• Ensure that the charging base has at least 0.5 m of free space on both
sides, and 1.5 m of free space in front.
• During installation, keep the power cable off the ground. When the power
cable is on the ground, it may be dragged by the device, which will cause
the charging base to power off.
• The charging indicator will remain on as long as electricity is flowing.
>0.5 m
>0.5 m
>1.5 m
