The Pyrotech Space Heater (Natural Gas Only) is approved for use with Pebbles.
To install the Pebbles follow the installation instructions as per Figures 1 to 5 above, and then
proceed as follows (Figures 10 to 12).
Note: If a coals only configuration is being used, use the same set up as pebbles.
Pyrotech Inbuilt Installation Procedure
(continued)
Figure (10) Install the metal angle at the rear of
the fireplace and place one row of
pebbles behind the burner rail.
Figure (11) Place pebbles between the first row
and the angled tray.
Figure (12) Place remaining pebbles up the
angle of the rear tray so as the tray
is hidden.
Replace the glass front to its original position.
Fit the trim to the front of the heater.
Light the unit following the procedure on page 17.
Install the 150mm AGA approved gas cowl where using the chimney to vent the fumes.
Test the unit for safe operation and show customer correct operating procedures.
Test for spillage.
Perform pressure test.
TICK BOXES
PYROTECH INBUILT MODEL
Note: Keep pebbles clear of burner rail.
8
