CMM 100 :
INSTALLATION, CALIBRATION AND OPERATION
11
NOTE 1: If the operator wishes to programme the instrument for alternative crops, then
they can if necessary, seek advice from either their RDS distributor or the
Factory Service Department
NOTE 2: The factory-default settings will be restored after a "Power-On Reset ".
3.2
Programming a Calibration Setting
Once you have selected the setting you wish to change (ref. section 3.1),
1.
Press and release
the button to select the digit you want to change.
00.00
00.00
00.00
00.00
2.
Press and hold
the button to change the digit.
3.
Release
the button when you have changed the digit.
4.
Repeat steps 1 to 3 for the remaining digits as necessary.
3.2.1 Entering a Negative Value
A negative value is indicated by the MIDDLE indicator on the left of the
display.
1.
Press and hold
the button to switch between negative and positive
value.
2.
Release
the button when you have changed it.
NOTE: If a positive value is set, the top and bottom indicators on the left of the
display disappear. If a negative value is set, the middle indicator remains as
shown below.
NOTE: If a particular setting does not support a negative value, then the side
indicators will not appear.
