ATHENE 100
– SPREADER RATE CONTROLLER
6
2
Switch functions in Normal Operating Mode
The front panel has five buttons. On systems configured for rate control, the
outer two buttons are used to adjust the application rate.
SELECT AREA TOTAL
Select the channel then
press to switch between Area
Total 1 and 2.
SET APPLICATION RATE
Select the channel then
HOLD for 3 seconds.
If the existing rate set = the
target rate,
then the target rate
is displayed and you can adjust
it using the rate + and –
buttons.
If the existing rate set is above
or below the target rate
, that
rate is set as the new target rate.
Press and hold the button
for 3 seconds to return to the
normal display.
Decrease Rate
Increase Rate
RESET
With “
tot.1
” or “
tot.2
” selected
on channel 2, HOLD for ten
beeps to reset the area register
to zero
SELECT CHANNEL
Ch.1
Forward Speed
Ch.2
Area Total 1 or 2
Ch.3
Work Rate
Ch.4
Appl. Rate/RPM
Ch.5
RPM -
Shaft/Spinner
Ch.6
Hopper Contents
Channel / Work
Status Indicator
Target Rate
Indicator
