ATHENE 100
– SPREADER RATE CONTROLLER
3
7.4
Nudging the Calibration ...............................................................................16
7.4.1
Under-application...........................................................................16
7.4.2
Over-application.............................................................................16
7.4.3
Setting a Nudge Factor ..................................................................16
7.4.4
Re-calculating the Calibration Factor .............................................17
7.4.5
Adjusting the Calibration Factor .....................................................17
8
RPM Display____________________________________ 18
8.1
RPM Alarm ...................................................................................................18
9
Hopper Contents Display ________________________ 19
9.1
Low Level Alarm (using Hopper Level Sensor) ............................................19
9.2
Weight display (Qty left in hopper/ Qty dispensed) .....................................19
9.3
The “Quantity in Hopper” display ................................................................20
9.3.1
Set Alarm Quantity..........................................................................20
9.3.2
Resetting the “Hopper Maximum Quantity” figure .........................20
9.3.3
Adjusting the “Hopper Maximum quantity” figure...........................21
“9.4 Quantity Dispensed” display........................................................................21
9.4.1
Resetting the “Quantity Dispensed” display to Zero.......................21
