RDC6585PC Control System manual
V1.0
SHENZHEN RUIDA TECHNOLOGY
65
After-feeding Time Lag
: settable at 0~9.9s. It can facilitate the feeding device
’
s
delaying in jarring after moving to the correct position and waiting for the 2
nd
work after the
feeding axle stands still completely.
Progressive feeding
: If this item is enabled, then the dummy array graph on Y
direction will run in the same position, running one line graph, the U axes moving one time to
feed, the moving length of U axes is the interval of the two lines graph on Y direction.
Progressive feeding repay
: Because of the imprecision of U axes
’
moving, there can
set a value to repay the interval of the two lines graph on Y direction.
Last feeding
: If feeding when the last times work end.
（
4
）
Reset parameters
Reset Speed
: it means the speed of X/Y-axle linkage reset to the origin.
Reset Speed of Z~D Axes
: the reset speed of Z~D axes go to the origin.
X~D axle start-up reset(Auto home)
:
You can select
“
Yes
”
or
“
No
”
in the field of the above six parameters, which is used to confirm
whether each axle can be reset on the startup.
（
5
）
Go scale parameters
Go scale Mode
:
“
Blanked Bordering
”
means idling to start border preview;
“
Outputted
Border Cutting
”
can manually cut off the well-processed figure;
“
4-corner Dotting
”
means to
emit the light at four corner points of the frame to make a point and turn off light. The size and
position of this figure can be checked intuitively through the four points. The bordering speed is
the speed value set on the keyboard when the system is idle. For light output, its
minimum/maximum power is the corresponding value set on the keyboard when the system is
idle (The lasering power on the 4-corner dotting means the well-set maximum power).
Go scale Blank
: It means whether to extend a certain length outside the actual frame
of the figure on the preview/cutting of frame.
If the frame crosses the border, the interface will prompt it. If the Enter key is
pressed at this time, the system will cut the border at the maximum/minimum
coordinates first, and then border the figure. This bordering can be given up.
（
6
）
Other user parameters
Array Mode
: Two-way array or one-way array can be selected. Two-way array means
the to-and-fro cutting of array in sequence; one-way array means the cutting of array from one
Prompt
