RDC6585PC Control System manual
V1.0
SHENZHEN RUIDA TECHNOLOGY
33
User can push
<Enter>
key to let the cursor move to the first layer show as below:
And then
“
Up and down
”
Keys can be pushed to select the intent layer, on that time, user can
push
<Enter>
key to check the selected layer
’
s parameters, When the processing mode of the
selected layer number is laser cutting, show as below:
When the processing mode of the selected layer number is glued, show as below:
At this point, the "blue selection block" stays on the layer number entry, and then press the
<Enter>
key to enter the selection layer mode, while the "blue selection block" becomes
, press
Figure 8.3-1
Figure 8.3-3
Figure 8.3-2
Figure 8.3-4
