RD RDC6585PC, Руководство пользователя

Страница: 72 / 77

RDC6585PC Control System manual V1.0
SHENZHEN RUIDA TECHNOLOGY 63
the absolute origin in the multi-head auto layout machine.

Multi-head number : the number of the all x axes in the multi-head auto layout
machine.

Driver type : single belt or multi- belt are selected.
（
4
）
Three-Color-Led Config Parameter

If Enable Three-Color-Led or Buzzer : If enabled, the output ports in controller will
drive the three-color-led and buzzer, then, these outputs be used to control other equipments.

Selecting in Idle/Run/Pause/Error Status : In Idle/Run/Pause/Error Status, user can
respectively select if turn on the led or buzzer.
9.2 User parameters
（
1
）
Cutting parameters(Only affect cutting arts)

Idle Move Speed : this parameter decides the highest speed of all non-lighting lines for
the machine in the movement process.

Idle Move Acceleration : it means the highest acceleration of all non-lighting lines. Idle
stroke speed and idle stroke acceleration can be set higher to reduce the working time of the
whole figure, but if they are set too high, it may cause the jarring of track, so comprehensive
consideration should be given to the setting.

Idle Move Delay
：
If this parameter is zero, then after idle moving there is no delay, or,
there is delay and the speed will decrease to turn off speed.

Turning Speed : it means the speed of turning at the acute-angle corner, which is also
the highest speed in the whole cutting process.

Turning Acceleration : it means the acceleration of turning at the acute-angle corner
when cutting. If the two speeds are set too high, jarring will happen to the turning; if set too
low, it will influence the cutting speed. This acceleration is the least value of the whole graph.

Cutting Acceleration : it means the highest acceleration value in the whole cutting
process.

Acc Factor : This parameter indicates how speedy the cutting acceleration is changing.

G0 Acc Factor : This parameter indicates how speedy the idle move acceleration is
changing.

Speed Factor : This parameter indicates the cutting speed of the arc of various
curvatures.