RCA P52151WK, Руководство пользователя

Страница: 4 / 56

The steps below will help you get your TV connected and
working quickly. The page numbers on which you can find
detailed instructions for each of these steps are also listed
for your convenience.
1.
Unpack TV and accessories.
.
Shown here are the accessories that came packed with your TV.
Four AAA Batteries for
R e m o t e
Remote Control
A d a p t e r
Install batteries in remote control.
Details are on page 8.
cord
Four Wing Nuts
Note: Only Model P46159 has a storage
compartment above the TV screen. When
unpacking this TV and before removing the
packing from around the glass doors, make
sure the glass doors have not shifted out of
their tracks during shipping. If the doors have
shifted, reinsert them into their tracks
carefully. Hold the side edges of the door and
insert the top edge into the upper track.
While lifting the glass door up into its upper
track, position the bottom edge of the glass
door over its corresponding lower track.
3. Extend back cover.
Back Collapsed
Your projection TV has been specially designed with a collapsible
back cover. This design makes it easier for you to move the TV
through doorways because the collapsed back makes the TV
narrower. After the TV is positioned in your home, you can
easily extend the back cover to its normal operating position by
following the instructions below.
Alignment
Hole for
Alignment
Hole for
1. Remove the four wing nuts from the literature bag.
Locating Pin
Locating Pin
2. Remove the two screws (labeled A) from the shipping
brackets. You will use these screws later in step 6.
3. Grasp the shipping brackets and gently pull the back cover
up and out until the locating pins enter the alignment holes.
Keep the back cover tight against the cabinet by holding the
shipping bracket on the right side. Then attach wing nut to
built-in hole screw in hole #1 . Hand tighten.
4. Hold left shipping bracket and attach wing nut to built-in
Back Extended
screw in hole Hand tighten.
5. Attach remaining wing nuts to screws in holes and to
ensure stability and best picture quality.
6. Remove the shipping brackets from the back cover and
attach them to the wooden rail with the two screws (A) from
Reinsert
other two
step 2. Reinsert the other two screws from the shipping
brackets into the back of the TV as shown, so they will be
available in case you need to move your TV and want to
collapse the back again.
screws
here
Wooden Rail