Razor rambler 20, Руководство пользователя

Страница: 4 / 16

HEADLINE
HEADLINE
33
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com . Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your
Rambler 20 was partially assembled and packed at the factory, there should not be any problems, even if the box has
a few scars or dents.
MAKE SURE POWER BUTTON IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR RAZOR Rambler 20.
The Rambler 20 has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on the
basis of its compatibility with the
frame and all other parts. Certain
aftermarket components may not
be compatible. Use of non-Razor
parts will void the warranty.
Product ID Locations:
(See locations to the left)
1. Battery Cover
2. Frame
3. Charger
4. UPC Side of Box (Not Shown)
Throttle
LED Headlight
LED Display
Kickstand
LED Tail/
Brake Light
Foot Pedals
(Left/Right)
1.
2.
Fork
Brake Levers
(Left/Right)
3.
Charger
(Note: Charger design may
vary from one shown)
BEFORE YOU BEGIN
MINIMUM LEG LENGTH
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 6 hours for charge
(see page 5 for charging information).