HEADLINE
HEADLINE
44
Box Contents:
• Rambler 20
• Charger
• Owner’s Manual
• Tools
Required Tools
6 mm Allen Wrench (Included)
13 mm/15 mm Wrench (Included)
BEFORE YOU BEGIN
ASSEMBLY AND SET-UP
Attaching the Handlebars
Required Tool:
6 mm Allen Wrench (included)
Place the handlebars in the handlebar clamps. Align parallel to the fork and
tighten the bolts using a 6 mm Allen wrench. When properly tightened, the
handlebars should not move forward or backward.
1
Align the hole in the RIGHT crank arm to insert the
right pedal (marked “R”).
3
Repeat step 1 to insert the LEFT pedal (marked “L”)
into the LEFT crank arm. Use a 15 mm wrench to install
LEFT pedal on LEFT crank arm.
Note:
the LEFT pedal is a reverse thread. To tighten, you
must turn the axle counterclockwise.
2
Use a 15 mm wrench to install the RIGHT pedal on
the RIGHT crank arm (the chain side). To tighten, turn the
axle clockwise. Tighten securely.
WARNING:
Failure to
properly tighten the handlebar
clamps may allow the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly tightened, the handlebars
will not rotate out of alignment
with the front wheel under normal
circumstances.
Note:
Make sure the brake cables/
wires are out of the way before
inserting the handlebar into the
handlebar clamps.
Attaching the Pedals
Required Tool:
15mm Wrench (included)
Содержание rambler 20
Страница 15: ......
